RAJE
Couldn't load pickup availability
This listing is for sample use only
Just pay shipping:
You will receive sample transfers or pieces of tranfers that did not pass our quality control. For instance incorrect color, smear, tears etc.
These are for you to test and to learn the process of pressing. These are not meant to be used for resale.
use a messup garnet to practice on.
please email rajenbdesigns@gmail.com if you have any questions
- Infant = 4 inches
- Toddler = 6 inches
- Youth = 8 inches
- Youth/Adult = 11 inches
- Adult=12 inches (Recommended)
- Adult XL = 13 inches
DTF Pressing Instructions:
- Pre-Heat Garment
- Lay down design on garment and then a teflon sheet on top of the design
- Press for 7 to 10 seconds on 290-300 degrees
- COLD PEEL
- Press again with teflon sheet on top for another 7 to 10 seconds
- DTF transfers can be pressed onto a variety of materials including: 100% Cotton 100% Polyester Poly/Cotton Blends
- DTF transfers can be used on ANY COLORED garment and the design will show full color!
- DTF transfers MUST be heat pressed on the material. You CANNOT use an iron.
- Actual product colors MAY vary slightly from display photo due to device display capabilities and monitor settings. Every print is different and has different color variations, especially in the watercolor graphics and/or after heat pressing. Please be aware of this before purchase as we DO NOT accept returns or exchanges for our products.
- We are not responsible for transfers that are pressed incorrectly. Please make sure you are using the correct material, color, and press settings prior to pressing your transfer.
WASHING INSTRUCTIONS:
When you apply the screen print to your item make sure you turn inside out to wash DO NOT USE FABRIC SOFTENER, Hang to Dry. If you are selling your finished product make sure you share these care instructions.
HIGH HEAT TRANSFERS-COMMERCIAL HEAT PRESS REQUIRED
Recommended for
- 100% Cotton
- 80% Cotton / 20% Poly
- 50% Cotton / 50% Poly
Application Instructions:
HIGH HEAT FULL COLOR
COMMERCIAL HEAT PRESS REQUIRED
- Preheat Garment if necessary to remove excess moisture
- Temperature: 350°F / 177°C
- Time: 7 - 10 seconds
- Pressure: 50- 60 PSI
- Hot Peel SLOWLY IF the ink is not releasing from the paper, rotate garment and press again.
- Do not use a teflon sheet or teflon bonnet between heat platen and transfer paper.
If you own a heat press which is Not one of our recommended brands, please follow the steps below.
- Increase your temperature +20°
- Preheat your garment for 7 - 10 seconds
- Use the Maximum pressure your machine will allow
- **We do not recommend “Bargain type” heat machines or hand held heat machines found on Amazon (typically cost less than $1200)
- Cricut Easy Press or Home Iron will not work with our heat transfers.
Washing Instructions:
Allow 24 - 48 hours to allow the garment to completely cure before machine wash. Wash inside out in cold water. Tumble dry low heat.
HIGH HEAT SINGLE COLOR TRANSFERS-COMMERCIAL HEAT PRESS REQUIRED
Recommended for
- 100% Cotton
- 80% Cotton / 20% Poly
- 50% Cotton / 50% Poly
Application Instructions:
- Preheat Garment if necessary to remove excess moisture
- Temperature: 375°F / 183°C
- Time: 7 - 10 seconds
- Pressure: 50- 60 PSI (Should be hard to close)
- Hot Peel SLOWLY IF the ink is not releasing from the paper, rotate garment and press again.
- Do not use a teflon sheet or teflon bonnet between heat platen and transfer paper.
If you own a heat press which is Not one of our recommended brands, please follow the steps below.
- Increase your temperature +20°
- Preheat your garment for 7 - 10 seconds
- Use the Maximum pressure your machine will allow
- **We do not recommend “Bargain type” heat machines or hand held heat machines found on Amazon (typically cost less than $1200)
- Cricut Easy Press or Home Iron will not work with our heat transfers.
Washing Instructions:
Allow 24 - 48 hours to allow the garment to completely cure before machine wash. Wash inside out in cold water. Tumble dry low heat.
You can check your pressure by placing a $1 bill on each corner of your press and close it. Tighten your pressure until you cannot pull the $1 bills out while your press is closed.
LOW HEAT TRANSFERS
Recommended for
- 100% Polyester
- 50/50 Cotton Poly blends
- 65/35 Cotton Poly blends
- 100% Cotton
Application Instructions:
- Preheat Garment if necessary to remove excess moisture
- Temperature: 325°F / 163°C
- Time: 7 - 10 seconds
- Pressure: 50- 60 PSI - #7 or Heavy pressure on a manual press
- Do not use a teflon sheet or teflon bonnet between heat platen and transfer paper.
If you own a heat press which is Not one of our recommended brands, please follow the steps below.
- Increase your temperature +10° to +20°
- Preheat your garment for 7 - 10 seconds
- Use the Maximum pressure your machine will allow
- Hot Peel SLOWLY IF the ink is not releasing from the paper, rotate garment and press again.
- **We do not recommend “Bargain type” heat machines or hand held heat machines found on Amazon (typically cost less than $1200)
- Cricut Easy Press or home Iron will not work with our heat transfers.
Washing Instructions:
Allow 24 - 48 hours to allow the garment to completely cure before machine wash. Wash inside out in cold water. Tumble dry low heat.
**If you are using a budget heat press, please check your platens with a heat gun (Touchless, Digital infrared Thermometer) to ensure your press is the correct temperature and that it has even heat across the platen. Soft Formula screens require even, heavy pressure. It should be hard to close your press.
You can check your pressure by placing a $1 bill on each corner of your press and close it. Tighten your pressure until you cannot pull the $1 bills out while your press is closed.
If the ink is not releasing from the paper, rotate the garment and press again.
Disclaimer
We can not guarantee any heat transfers wash-ability due to the fact there is no way to prove our product was applied and washed properly according to our recommended guidelines. Our products are tested prior to leaving our warehouse.
**NOT RESPONSIBLE FOR TOPS, BOTTOMS, BAGS or ANY Items used to press our Screen Print/DTF/Sublimation Transfers on**
Shipping & Returns
Shipping & Returns
Care Instructions
Care Instructions
